Tuff Country 26814 - Ford 80-96 6 box kit User Manual
Page 3
Special note: Before installation begins, it is the
customers/installers responsibility to make sure that all
parts are on hand. If any parts are missing, please feel
free to call one of our customer service representatives
@ (801) 280-2777.
Hardware bag F6XRB-NB includes:
Description
Quantity
716112B (7/16” x 1 1/2” bolt)
4
716UN (7/16” unitorque nut)
4
38WA (3/8” USS flat washer)
8
12112B (1/2” x 1 1/2” bolt)
17
12UN (1/2” unitorque nut)
17
716WA (7/16” USS flat washer)
34
Hardware bag F4XRB-NB1 includes:
Description
Quantity
PB2408 (poly bushing)
4
S10081 (.875” x .563” x 2.080” sleeve)
2
CAM-01 (9/16” x 3 1/2” cam bolt)
2
CAM-02 (cam washer)
8
CAM-03 (9/16” x 4” cam bolt)
2
916UN (9/16” unitorque nut)
4
SERT (sert fittings)
2
LUBE (poly lube pack)
2
Hardware bag FBLNB2 includes:
Description
Quantity
BLR013 (front brake line bracket)
2
BLR014 (rear brake line bracket)
1
5161B (5/16” x 1” bolt)
3
516UN (5/16” unitorque nut)
3
14WA (1/4” USS flat washer)
6
ECLIP (e-clip)
3
Recommended tools selection:
Cut off wheel
Torque wrench
Standard socket set
Standard wrench set
Metric socket set
Metric wrench set
Tape measure
Hydraulic floor jacks
Air chisel
Drill bits
Drill
Please follow instructions carefully:
Before installation begins, measure from the center of
the hub, to the bottom of the fender well, and record
measurements below.
Pre-installation measurements:
Driver side front:_________________________________
Passenger side front:_____________________________
Driver side rear:__________________________________
Passenger side rear:______________________________
At the end of the installation take the same
measurements and compare to the pre-installation
measurements.
Post-installation measurements:
Driver side front:_________________________________
Passenger side front:_____________________________
Driver side rear:_________________________________
Passenger side rear:______________________________
Front end installation:
1. To begin installation, block the rear tires of the vehicle so
that the vehicle is stable and can’t roll backwards. Safely lift
the front of the vehicle and support the vehicle with a pair of
jack stands. Place a jack stand on both the driver and the
passenger side. Special note: Place the jack stands on
the body mounts, this will allow for the new extended
radius arms to be installed. Next, remove the front wheels
and tires from both sides.
2. Working on the driver side, remove the stock shock from
the stock upper and lower mounting location. Save the stock
lower mounting hardware. The upper mounting hardware
and shock may be discarded. Special note: Some vehicles
come stock with multiple shocks in the front end. Repeat
procedure on the passenger side. Special note: New
longer front shocks are needed after this suspension
system has been installed and the front shocks need to
be ordered as a separate part #. If you have not already
ordered your front shocks, please feel free to contact
Tuff Country or your local Tuff Country dealer and order
your front shocks. Tuff Country recommends installing
a 23” fully extended nitrogen gas in the front and a 26”
fully extended cellular shock in the front for the auxiliary
shock.