Tuff Country 26814 - Ford 80-96 6 box kit - Manual (Page 9)

32. Locate (4) PB2408 poly bushings, (2) S10081 sleeves
from hardware bag F4XRB-NB1. Install the bushings and
sleeves into the eyelet ends of the new extended radius
arms. Special note: Make sure to use a lithium or moly
base grease prior to inserting the bushings and sleeves
into the new extended radius arms. This will help
increase the life of the bushings as well as prevent
squeaking.
33. Locate the stock lower shock bracket and hardware.
Also, locate the top stock bolt that connected the stock radius
arm to the stock front twin eye beam axle. Working on the
driver side, install the new driver side radius arm to the stock
front twin eye beam using the lower shock bracket and the
stock hardware. Make sure to use some thread locker or loc-
tite. Torque the top stock bolt to 145 ft lbs. and the shock
bracket hardware to 45 ft lbs. Special note: A good way to
tell the difference between the new driver and passenger
side extended radius arms is when they are installed,
they will angle towards the center of the vehicle then out
to the new extended radius arm relocation brackets.
Repeat procedure on the passenger side.
34. Locate the bottom stock bolt that connected the stock
radius arm to the stock front twin eye beam. Working on the
driver side, secure to newly installed driver side extended
radius arm to the bottom of the stock front twin eye beam
using the stock hardware. Make sure to use thread locker or
loctite and torque to 145 ft lbs. Repeat procedure on the
passenger side.
35. Locate (2) 9/16” x 4” cam bolts, (4) cam washers and (2)
9/16” unitorque nuts from hardware bag F4XRB-NB1.
Working on the driver side, install the newly installed driver
side extended radius arm into the newly installed driver side
extended radius arm relocation bracket and secure using
the new cam bolts and hardware. Make sure to add some
thread locker or loctite and torque to 95 ft lbs. Special note:
For now, place the cam washer in the center position.
Repeat procedure on the passenger side. These photos
are showing the driver side extended radius arm and the
extended radius arm relocation bracket.
36. Locate the stock lower coil spring/sway bar brackets.
Working on the driver side, install the stock lower coil
spring/sway bar bracket into the stock location. Repeat pro-
cedure on the passenger side.