Tuff Country 32902 - Dodge 2006-11 Ram 1500 4wd 2 leving kit - Manual (Page 3)

Special note: Before installation begins, it is the
customers/installers responsibility to make sure that
all parts are on hand. If any parts are missing, please
feel free to call one of our customer service rep-
resentatives @ (801) 280-2777.
Recommended tools selection:
Torque wrench
Standard socket set
Standard wrench set
Metric socket set
Metric wrench set
Tape measure
Hydraulic floor jacks
Please follow instructions carefully:
Before installation begins, measure from the center of
the hub, to the bottom of the fender well, and record
measurements below.
Pre-installation measurements:
Driver side front:_______________________________
Passenger side front:___________________________
At the end of the installation take the same
measurements and compare to the pre-installation
measurements.
Post installation measurements:
Driver side front:______________________________
Passenger side front:__________________________
Front end installation:
1. To begin installation, block the rear tires of the vehicle so
that the vehicle is stable and can’t roll backwards. Safely lift
the front of the vehicle and support the frame with a pair of
jack stands. Place a jack stand on both the driver and pas-
senger side. Next, remove the wheels and tires from both
sides.
2. Working on the driver side, remove the stock sway bar
end link from the stock sway bar. Save the stock hardware.
Special note: The sway bar end link does not need to
be removed from the stock lower control arm.
3. Working on the driver side, remove the stock outer tie rod
nut that connects the tie rod to the knuckle. Save the stock
hardware.
4. Working on the driver side, remove the stock outer tie rod
from the the stock knuckle.
5. Working on the driver side, remove the stock hardware
that connects the upper control arm to the knuckle. save the
stock hardware.
6. Working on the driver side, remove the upper control arm
from the knuckle. Let the knuckle hang. Special note: make
sure not to over extended any brake hose and or wires.