Tuff Country 32902 - Dodge 2006-11 Ram 1500 4wd 2 leving kit - Manual (Page 5)

16. Locate the stock sway bar end link hardware and secure
to stock sway bar to the stock end link. Add some thread
locker or lock tite and torque to 32 ft lbs.
17. Move back to the stock outer tie rod that connects to the
knuckle and torque to 65 ft. lbs.
18. Move back to the stock upper control arm that connects
to the knuckle and torque to 85 ft lbs.
19. Repeat step’s 2 - 18 on the passenger side.
20. Check and double check to make sure that all steps were
performed properly and check again.
21. Install the tires and wheels and carefully lower the vehi-
cle to the ground.
Special note: After the completion of the installation,
Tuff Country EZ-Ride Suspension recommends taking
the vehicle to an alignment shop and having a proper
front end alignment performed.
Tuff Country EZ-Ride Suspension recommends that a
complete re-torque is done on all bolts associated with
this suspension system. It is the customers responsibil-
ity to make sure that a re-torque is performed on all
hardware associated with this suspension system after
the first 100 miles of installation. It is also the customers
responsibility to do a complete re-torque after every
3000 miles or after every off road use. Neglect of follow-
ing these steps could cause brackets to come loose and
cause serious damage to the suspension system and to
the vehicle.
If you have any questions or concerns, please feel free
to contact Tuff Country or your local Tuff Country
dealer.