Tuff Country 33119 - Dodge 2013-2014 Ram 4wd 3 lift kit User Manual
Page 3
Recommended tools selection:
Torque wrench
Standard socket set
Standard wrench set
Metric socket set
Metric wrench set
Tape measure
Hydraulic floor jacks
Hardware bag 33118NB includes:
Description
Quantity
381B (3/8” x 1” bolt)
2
516WA (5/16” USS flat washer)
4
38UN (3/8” unitorque nut)
2
12114B (1/2” x 1 1/4” bolt)
1
716WA (7/16” USS flat washer)
2
12UN (1/2” unitorque nut)
1
M1890B (18 mm x 90 mm bolt)
1
M18WA (18 mm flat washer)
2
M18UN (18 mm unitorque nut)
1
Hardware bag 916NW includes:
Description
Quantity
916HN (9/16” u-bolt high nut)
8
SUW-916 (9/16” harden u-bolt washer)
8
Please follow instructions carefully:
Before installation begins, measure from the center of
the hub, to the bottom of the fender well, and record
measurements below.
Pre-installation measurements:
Driver side front:_________________________________
Passenger side front:_____________________________
Driver side rear:__________________________________
Passenger side rear:______________________________
At the end of the installation take the same
measurements and compare to the pre-installation
measurements.
Post-installation measurements:
Driver side front:_________________________________
Passenger side front:_____________________________
Driver side rear:_________________________________
Passenger side rear:______________________________
Front end installation:
1. To begin installation, block the rear tires of the vehicle so
that the vehicle is stable and can’t roll backwards. Safely lift
the front of the vehicle and support the vehicle with a pair of
jack stands. Place a jack stand on both the driver and the
passenger side. Next, remove the front wheels and tires
from both sides.
2. Place a pair of hydraulic floor jacks under the front axle.
Place one on the driver side and passenger side. Carefully
raise up on both hydraulic floor jacks at the same time until
they come into contact with the front axle.
3. Working on the driver side, remove the shock from the
upper and lower mounting location and save the lower
mounting hardware. The upper hardware and shock may be
discarded. Repeat procedure on the passenger side.
Special note: Once this Suspension Kit has been
installed, longer front shocks will be need and the front
shocks need to be ordered as a seperate part #. If you
have not already ordered your new front shocks, please
contact Tuff Country or your local Tuff Country dealer
and order your new front shocks. Tuff Country EZ Ride
Suspension recommends installing a 26” fully extended
shock in the front.
4. Working on the driver side, remove the sway bar end link
from the sway bar. Save the hardware. Repeat procedure on
the passenger side.