Tuff Country 33119 - Dodge 2013-2014 Ram 4wd 3 lift kit - Manual (Page 6)

14. Locate the new S10242 sleeve. Also, locate (1) 18 mm x
90 mm bolt, (2) 18 mm flat washers and (1) 18 mm unitorque
nut from hardware bag 33118NB. Using the new 18 mm bolt,
hardware and sleeve, secure the new track bar relocation
bracket to the stock track bar bracket OE hole. Do not tight-
en at this point. Special note: The new sleeve will be
installed inside the OE bracket.
15. Move back to the 1/2” x 1 1/4” hardware attaching the
new bracket to the OE bracket and add some loctite and
torque to 38 ft lbs.
16. Move back to the 18 mm hardware attaching the new
bracket to the OE location and add some loctite and torque
to 95 ft lbs.
17. Install the track bar to the newly installed track bar brack-
et and secure using the OE hardware. Make sure to use loc-
tite and torque to 145 ft lbs. Special note: If you are not
able to install the track bar to the newly installed track
bar bracket, this step will need to be performed when
the suspension system is completely installed and the
weight of the vehicle is on the ground.
18. Carefully lower down on both hydraulic floor jacks at the
same time allowing enough room for the coil springs to be
removed. Working on the driver side, remove the coil spring
and set aside. Repeat procedure on the passenger side.
Special note: Take special care not over extend any
brake lines or hoses.