Avocent DSR1161 - Manual (Page 30)

24 DSR Installer/User Guide Chapter 3: Local Port Operation 25
3. In the Repeat box, type the password again and press Enter.
4. Click OK (if you only want to change your password) and then close the
dialog box.
To password protect your console:
1. Set your password as described in the previous procedure.
2. Select Enable Screen Saver.
3. Type the number of minutes for Time Delay (from 1 to 99) to delay
activation of password protection and the screen saver feature.
4. For Mode, select Energy if your monitor is EnergyStar™ compliant;
otherwise select Screen.
CAUTION: Monitor damage can result from the use of Energy Mode with monitors not
compliant with EnergyStar.
5. Click Test to activate the screen saver test which lasts 10 seconds then
returns you to the Security dialog box (optional).
6. Click OK.
To log in to your console:
1. Press any key on the keyboard or move your mouse. The Password dialog
box appears. Type your password, and then click OK.
2. Press Print Screen to start the OSCAR GUI.
To remove password protection from your console:
1. From the Main dialog box, click Setup-Security; the Password dialog box
appears. Type your password, and then click OK.
2. In the Security dialog box, single-click and press Enter or double-click in
the New box. Leave the box blank. Press Enter.
3. Single-click and press Enter or double-click in the Repeat box. Leave the
box blank. Press Enter.
4. Click OK if you only want to eliminate your password.
To enable the screen saver mode with no password protection:
1. If your console does not require a password to gain access to the Security
box, go to step 2.
—or—
If your console is password protected, see previous procedure then go to
step 2.
2. Select Enable Screen Saver.
3. Type the number of minutes for Time Delay (from 1–99) that you want to
delay activation of the screen saver.