Tuff Country 52070 - Toyota Tundra 07-13 2 leveling kit - Manual (Page 6)

19. Locate the sway bar end link mounting hardware.
Working on the driver side, secure the sway bar end link to
the lower control arm using the OE hardware. Add some loc-
tite and torque to 60 ft lbs.
20. Locate the lower strut mounting hardware. Working on
the driver side, secure the lower strut to the lower control
arm using the OE hardware. Make sure to add some loctite
and torque to 100 ft lbs.
21. Move back to the (4) upper nuts that are connecting the
newly modified strut into the upper location and add some
loctite and torque all (4) nuts to 50 ft lbs.
22. Remove the hydraulic floor jack from under the driver
side lower control arm.
23. Locate the stock control arm castle nut. Install the upper
control arm to the knuckle and secure using the castle nut.
Make sure to add some loctite and torque to 80 ft lbs.
24. Locate the upper control arm cotter pin. Working on the
driver side, install the cotter back into the upper control arm
ball joint. Special note: If the cotter pin can not be
installed because the hole in the castle nut does not line
up with the ball joint, DO NOT loosen the castle nut so
that the cotter pin can fit, tighten the castle nut some
more so that the cotter pin can be installed.
25. Locate the outer tie rod castle nut. Working on the driver
side, install the outer tie rod the knuckle and secure using
the castle nut. Make sure add some loctite and torque to 67
lbs.
26. Locate the outer tie rod cotter pin. Working on the driver
side, install the cotter back into the outer tie rod ball joint.
Special note: If the cotter pin can not be installed
because the hole in the castle nut does not line up with
the ball joint, DO NOT loosen the castle nut so that the
cotter pin can fit, tighten the castle nut some more so
that the cotter pin can be installed.
27. Locate the brake line mounting hardware. Working on
the driver side, secure the brake line bracket to the knuckle
and secure using the OE hardware. Make sure to add some
loctite and torque to 12 lbs.
28. Locate the ABS mounting hardware. Working on the driv-
er side, secure the ABS bracket to the upper control arm and
secure using the hardware. Make sure to add some loctite