Anthem AVM 50v 3D - Manual (Page 71)

4.8.10 DOLBY VOLUME AND DYNAMICS
To use Dolby Volume according to its settings in the level calibration and source setup menus press
DYNAMICS and use the Master Control Knob or
56 keys on the remote control to select On/Off.
Sources often have dynamic range controls as well. Be sure to disable them to get the most from the
processor’s dynamics control. In some cases the setting names in sources are confusing because
“Extended” can mean dynamics are left alone while “Normal” can mean they’re reduced. Check source
operating manuals to find what their settings mean and under what conditions they apply.
When Dolby Volume is Off another option becomes available after DYNAMICS is pressed
a second time. This also allows you to control the difference between the softest and
loudest passages, but only on multichannel Dolby Digital and DTS soundtracks that
contain dynamic scaling cues. At least 5.1 speakers must be used. Use the Master
Control Knob or
56 keys on the remote control to select:
Reduced: Allows the quieter parts to be heard more easily, and works by raising the level of quieter
sounds and/or reducing the level of louder ones according to cues in the soundtrack.
Late Night: Further reduces the softest-to-loudest difference.
Reduced and Late Night are reset to Normal when Main power is turned off.
4.9 LIP-SYNC DELAY (remote control only)
To adjust lip-sync while playing a video source instead of viewing the setup menu, press and hold
the DISPLAY key until the display shows “LIP-SYNC DELAY”, then use the
34 keys to move from
digit to digit and the 56 keys to adjust.
4.10 DISPLAY BRIGHTNESS (front panel only)
To change the brightness of the front panel display and LED indicators, press DISPLAY
and use the Master Control Knob to select Maximum, High, Medium, Low, or Off.
63
4. OPERATION
continued …