AVE MV DR4000 - Manual (Page 82)

80
13.4 Change Pan/Tilt/Zoom Setting
Please follow the steps provided below to control the Pan/Tilt/Zoom setting through the network as and
when necessary.
1. Click the button on the home page to open the Speed Dome Controller.
2. Click the button to control the Zoom setting on the Speed Dome Controller.
3. The right-hand set, , has four buttons, each of which, upon being clicked, will turn the
camera all the way, without stopping, in one of the four designated directions. The fifth button, in
the center, will stop the camera at any point you prefer.
4. The left-hand set of buttons, , has four buttons, each of which, upon being clicked, will
move one short step only in any of the four designated directions.
5. Select a Speed Dome device Model from the drop-down list on the
SpeedDome Controller. The Controller will be able to display the Model by turn.
6. Select a Speed Dome device ID from the drop-down list on the Speed Dome
Controller. The Controller will be able to display the ID by turn.
7.
Each of the ten buttons under ‘Set’ is connected with a specific position and angle of either
panning or tilting of the camera. Click each button to activate its particular position and angle.
Press the button under ‘Preset‘ to turn the camera angle by angle in the set positions.
Each of the ten buttons under ‘Clear’ can be clicked to delete the corresponding ‘Set’ button above
it. For example, if you wish to de-activate ‘Set’ button #4, please click ‘Clear’ button #4 to delete its
corresponding ‘Set’ counterpart.
Each of the ten buttons designated ‘Go to’ can be clicked to view the particular corresponding
angle of the position in which it is set.