AmpliVox SW124 - Manual (Page 5)

5
Wireless Transmitter—Model SW124
The transmitter bodypack is operated by 1 - "AA"
alkaline battery. Before use, install battery as
shown (Fig. 4). Make certain the battery is fully
seated in its compartment so the cover slides in
place easily. Battery life with alkaline batteries is
approximately 8 hours of operating time.
When LED on top panel turns to RED the battery
should be replaced immediately.
15. Wireless 16 Channel Selector
(Model SW124)
—rotate knob to select
wireless channel on the built-in receiver. RF
LED will light up when receiving signal from
transmitter.
Wireless 16 Channel UHF
Bodypack Microphone
Transmitter
Channel selected must match
Turn amplifier on. Turn microphone on and talk into microphone (SS124). Rotate “VOLUME” control knob to obtain desired
loudness level. For Model SW124, the built-in wireless receiver ON-OFF switch is located just below main power switch of am-
plifier. Turn wireless on and insure both transmitter and receiver are on same frequency channel. Rotate the Channel Selector
Switch (B) to the desired channel with a small screwdriver. Channel must match channel selected on transmitter (
A ).
Belt clip on the back of the unit clips the transmitter onto a belt or the transmitter simply can be put into a pocket. Plug the micro-
phone into the Mic Input Jack. The microphone can be clipped to a necktie or other clothing, using the supplied clip.
The lapel mic should be placed under the chin, as close to the center of the body as possible.
Turn on power switch located on wireless transmitter, RF LED under the channel selector (receiver) on amplifier panel will light,
meaning that it is receiving signal. If RF LED does not light, check channel numbers. When both RF LED’s are on, speak into
microphone and rotate “VOLUME” control knobs to obtain desired loudness level.
To Operate:
B
A