Monoprice 4652 Recessed Pro Power Kit - Manual (Page 2)

Parts Included:
1. 45-0021-WH Recessed Low Voltage Cable Plate with
Recessed Power
2. Recessed Low Voltage Cable Plate with Recessed
Straight Blade Inlet
3. 6 Ft. 14/2 with Ground Extension Cord
4. Three (3) Wire Nuts
5. Two (2) Old Work Electrical Boxes
Use the Recessed Low Voltage Cable Plate with Recessed
Straight Blade Inlet to install power and low voltage cables
behind your flat panel TV, amplifier or other audio and video
devices to your equipment room or at the location of your head
end equipment.
IMPORTANT INSTRUCTIONS:
 Use the local electrical code approved installation when
installing this product.
 The electrical parts in this kit are designed to be used
only as a kit and none of these electrical parts are
designed to be used individually.
 This product is not designed to be part of your home or a
commercial building’s electrical wiring system.
 This installation is only energized (electrically active)
when the supplied 6 ft. cord is plugged into the recessed
straight blade inlet located on the recessed low voltage
cable plate and the straight blade end of the 6 ft. cord is
plugged into either your surge protector or wall
receptacle.
 If you are not familiar with home wiring systems, please
call a qualified electrician to install this product.
Installation Instructions for New Construction:
Simply use a new nail on box and follow all other instructions
described in the retrofit portion of the instruction sheet.
Installation Instructions for Retrofit Only:
1.
Select the location of your flat panel TV mounting
bracket. Now select the location for both the 45-0021-
WH Recessed Low Voltage Cable Plate with Recessed
Power and the Recessed Low Voltage Cable Plate with
Recessed Straight Blade Inlet.
2. Both the Recessed Low Voltage Cable Plate with
Recessed Power and the Recessed Low Voltage Cable
Plate with Recessed Straight Blade Inlet are designed to
be mounted between two studs (see Figure 1). Using
the template supplied (see back of instruction sheet),
trace the openings needed for both recessed cable
plates. Using a drywall knife cut a hole in the drywall the
size of the template.
3. Remember that the Pro-Power Kit is not part of your
home’s electrical wiring system. Before installing the
single gang retrofit workboxes (see Figure 2), pull a
piece of 12/2 or 14/2 with ground UL approved building
wire from one opening to the other opening to connect
the recessed cable plate with recessed power to the
recessed cable plate with recessed straight blade inlet.
Make sure the piece of wire is long enough to allow for
easy installation of the receptacles. Insert a single gang
retrofit workbox (see Figure 2). Securely fasten the
workbox to the wall.
DataComm Electronics, Inc.
6349 Peachtree Street
Norcross, GA 30071-1725
888.223.7977
770.662.8205
www.datacommelectronics.com
Instruction / Installation Sheet
DataComm Electronics 45-0023-WH Recessed Pro-Power Kit with Straight Blade Inlet
Figure 3 Figure 4
Figure 1 – Front View
Figure 2 – Back View
3/19/10 Rev. 9