Monoprice 7535 MS-03 - Manual (Page 3)

1
4 3
Attachment of footpad to metal base
1b. For carpet placement
Place speaker stand base(A) upside down on ground and thread steel isolation spikes (M-C) through M6 nut
(M-E)in the 4 holes.Adjust the height of speaker stand base by screwing the nut as request .as shown in fig.1.2.
1a. For hard floor placement
Place speaker stand base(A) upside down on ground and paste rubber footpad on the 4 holes, as shown in fig.1.1
2 Attachment of speaker stand base to pillar
•Insert pillar (B) from the bottom of speaker stand base and turn pillar to align to mounting hole, Secure them with
M5x12(M-A)screw. Then tighten the screw ,but do not over tighten.
•Turn the base over ( isolation spikes can scratch floors, use caution) Please ensure cable outlet on top of pole is
in line with channel in base.as shown in fig.2.1.
Mounting plastic cover 3
Cover the speaker stand with the plastic cover (E) through pillar. as shown in fig.3.1
fig.1.1
M-D
A
fig.1.2
M-C
M-E
A
M-A
B
fig.2.1
fig.3.1
B
E