Monoprice 8099 MDA03-222 - Manual (Page 2)

NOTE: Read entire instruction sheet before you start installation and assembly.
WARNING
• Do not begin the installation of the product before you have read and understood the
instructions and warnings contained in this installation sheet. If you have any question
regarding any of the instruction or warning, Please contact your local distributor.
• Please refer to installation guide recommendation for required distance from wall to
avoid risk of property damage.
• This product should only be installed by someone of good mechanical aptitude, with
experience and basic building, and fully understands.
• Make sure that the supporting surface will safely support the combined load of the
equipment and all attached hardware and components.
• Never exceed the maximum load capacity.
• If mounting to wood wall studs, make sure that mounting screws are anchored into
the center of the studs. Use of an “edge to edge” stud finder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position
equipment.
• Tighten screws firmly, but do not over tighten. Over tightening can damage the items,
greatly reducing their holding power.
• This products intended for indoor use only. Using this product outdoors could lead to
product failure and personal injury.
2 1
Component Checklist
IMPORTANT: Ensure you have received all parts against the component checklist prior to installing. If any parts
are missing or faulty, telephone the special franchiser for a replacement.
Package M
Package W
Tools required
Phillips Head Screw driver(200mm length exclude the handle)
Electric drill and 8mm masonry bit for concrete wall installation
Marking Pen
Hammer ·
·
·
·
ST 5.5x50 (x3)
W-A
lag bolt concrete anchor
W-B
(x3)
M4x14
M-A
(x4) M5x14 (x4)
M-B
D4 ( 4.5x )
washer
M-E
ш ш10
(x4)
D (ø .5xø )
(x4)
5 5 12
washer
M-F
3mm allen key (x1)
M-J
M6x14 (x4)
M-C
D6 (ø6.3xø )
(x4)
16
washer
M-G
M8x15 (x4)
M-D
D8 (ø8.3xø )
(x4)
16
washer
M-H
ø13.5xø5.5x3.2 (x4)
M-I