Monoprice 8099 MDA03-222 - Manual (Page 3)

4 3
WOOD STUD WALL MOUNTING: 1a
WARNING
• Make sure that the supporting surface will safely support the combined load of the
equipment and all attached hardware and components.
• Tighten wood screws firmly, but do not over tighten. Over tightening can damage
the screws, greatly reducing their holding power.
• Make sure that mounting screws are anchored into the center of the studs. Use of
an “edge to edge” stud finder is highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall
or plaster into studs. Installers are responsible to provide hardware for other types
of mounting situations.
SOLID BRICK AND CONCRETE BLOCK MOUNTING: 1b
WARNING
• When installing wall mounts on cinder block, verify that you have a minimum of
1-3/8” of actual concrete thickness in the hole to be used for the concrete anchors.
Do not drill into mortar joints! Be sure to mount in a solid part of the block,
generally 1” minimum from the side of the block. It is suggested electric drill on
slow setting is used to drill the hole instead of a hammer drill to avoid breaking out
the back of the hole when entering a void or cavity.
• Installer must verify that the supporting surface will safely support the combined
load of the equipment and all attached hardware and components.
Stud
fig. 1.1
• Use a stud finder to locate the edges of the studs. Use of an edge-to-edge stud finder is highly
recommended. Based on their edges, draw a vertical line down each stud’s center.
• Place wall plate on wall as a template. And mark the center of the three mounting holes. Make sure that
the mounting holes are on the stud centerline.
• Drill three 1/8” (3mm) dia. Holes 1.2” (30mm) deep. Make sure that the wall plate is level, secure it using
three wood screws (W-A) as shown in fig. 1.1.
• Use the Wall Plate as a template to mark 3 holes locations on the wall, as shown in fig.1.2.
• Pre-drill these holes with a 8mm masonry bit to at least 50mm in depth. Insert a Concrete Anchor (W-B)
into each of these holes. Attach the Wall Plate to the wall using 3 wood screws (W-A) as shown in fig.1.3.
W-A
Disassemble the adapter bracket from the assemble product to easy for installation, Loosen the safety
screws by using 3mm allen key(M-J) and take the adapter bracket off articulated arm assemble. as shown
below.