Monoprice 9204 IP Camera - Manual (Page 20)

MPEG-4 wired/wireless IP Camera
3.4. WiFi security (For Cam(w))
You can use the wireless to connect the IP Camera to the network. If your
network environment has a 802.11 b/g router or AP running, you can check the
“Enable WiFi function” button to use the wireless.
Figure 3-7: WiFi security disabled page
In order to use the wireless network, you need to fill the following fields:
1. SSID – this is the ID of the wireless router or AP of your wireless network
environment, must be set correctly.
2. Security mode – this is the security mode used in the wireless router or AP. Need
to choose one of the three modes – None, WEP and WPA-PSK.
WEP : Wireless Encryption Protocol.
WPA : WiFi Protected Access.
PSK : Pre-Shared Key.
TKIP : Temporal Key Integrity Protocol.
AES : Advanced Encryption Standard.
3. WEP mode – when the WEP mode is chosen, you need also choose between
64-bit(5 char), 64-bit(10 hex), 128-bit(13 char) and 128-bit(26 hex) encryption
mode, and then fill the WEP key correctly.
4. WPA-PSK mode - when the WPA-PSK mode is chosen, you need also choose
between TKIP and AES encryption mode, and then fill the WPA-PSK key correctly.
WPA2-PSK is also supported. But WPA Enterprise or WPA2 Enterprise is not
supported.
All the fields in this page must be filled correctly with the same settings the
20