Monoprice 8816 2DNR - Manual (Page 18)

BACKLIGHT
This function is used to compensate for exposure problem associated with
extremly bright backgrounds causing the subjects to bloom or silhouette.
ATW1 (Auto Tracing White Balance mode 1):
Select the ATW1 mode to automatically adjust the color temperature according
to its ambient condition. (2,300~9,500K)
ATW2:
Select the ATW2 mode if the color temperature of the light source is between
2,000~11,000K.
AWC (Auto White Balance Control):
Use the AWC function to correctly calibrate the white balance of the camera.
While in this mode, press the SET key while placing a white sheet of paper in
front of the camera. Repeat this procedure if there is a change in location or
light source.
MANUAL: INDOOR, OUTDOOR, MANUAL
If you press the SET key, you can adjust color temperature manually.
The Blue and Red values can be adjusted independently only in the Manual
mode.
- INDOOR: Sets the color temperature properly for the indoor condition.
- OUTDOOR: Sets the color temperature properly for the outdoor condition.
- MANUAL: Adjust the strength of the red color or the blue color manually.
The BLC divides the frame and calculates exposure levels of each zone to
counterbalance excessive background light in order to distinguish the subject
in the foreground. There are 2 white boxes representing the areas affected
by BLC. Each boxes can be individually adjusted to user preference.
BLC (Back Light Compensation):
18