Monoprice 8816 2DNR - Manual (Page 23)

> AREA SEL. (AREA1~4): Choose one of four pre-defined boxes to adjust its
size or location.
> AREA STATE (ON,OFF): Select a box active or inactive for motion detection.
> HEIGHT, WIDTH: Adjust the height or width of the area.
> LEFT/RIGHT, TOP/BOTTOM: Changes the location of the defined area.
> DEGREES (0~255): Increases or decreases the sensitivity of the selected
area. Increasing the number decreases sensitivity.
> VIEW (ON,OFF): Turns the “Running Man” indication On or Off.
> RETURN: Select RET to save and exit, and to go back to the MAIN MENU.
> AREA SEL. (AREA1~8): Choose one of 8 colored boxes to adjust its size or
location.
> AREA STATE (ON,OFF): Select a box active or inactive for privacy masking.
> HEIGHT, WIDTH: Adjust the height or width of the area.
> LEFT/RIGHT, TOP/BOTTOM: Changes the location of the defined area.
> COLOR (1~15): Choose one of 15 colors for the masked area.
> VIEW (ON,OFF): Turns the “Running Man” indication On or Off.
> RETURN: Select RET to save and exit, and to go back to the MAIN MENU.
This function is used to mask specific areas within the frame of the camera
to be concealed. There are total of 8 different colored boxes representing the
masked areas. Each boxes can be individually adjusted to user preference.
PRIVACY : ON, OFF
This function is used to compensate for the dead pixel areas of the screen.
When a defective pixel is detected, a neighboring pixel information is used
to determine the approximate pixel data and is replaced. The DPC is capable
of compensating up to 64 points of dead pixels.
DPC (Dead Pixel Compensation)
VERSION
The camera firmware version is displayed.
23