Monoprice 9306 H.264 DVR User Manual
Page 12
4/8/16Channel DVR Quick Manual
11
Operate the PTZ with mouse through the keypad on the interface. Set the cruise point in
the cruise setup, as shown on the right picture above.
2.7 Motion Detection
Enter the Motion Detection screen from “Main Menu” →“Advanced” to “Motion Detection”,
as shown below:
STATUS: Each channel has a corresponding
switch. Select “On” or “Off”.
SENSITIVITY: Each channel has a corresponding
sensitivity setting, with the 4 levels of 1, 2, 3
and 4, in which 4 is the highest. Select
sensitivity for confirmation.
MD AREA: Each channel has a corresponding
motion detection area setting. Move the cursor
to “Setup” of the corresponding channel, and press “Enter” to enter the motion area setup
screen of this channel, where a red block indicates motion detection is activated for this
area and a transparent block indicates motion detection is not activated, as shown below.
Motion detection setup procedures:
A.
Turn “On” the corresponding channel in the
“Channel Switch” option;
B.
Set the sensitivity level as necessary, usually set
at 3 or 4;
C.
Set the motion area of the corresponding
channel in the “Area Setup” option;
D.
In the “Recording Mode” screen, set the
corresponding channel to “On” in the “Channel”
option;
E.
In the “Recording Mode” screen, select “Timing Recording” in the “Recording Mode”
option, also click “Record Time Configuration” to enter the Record Time
Configuration screen and set the corresponding time to alarm recording (see timing
recording in “Recording Mode” for the setup method).
After the setup has been done and motion detection is triggered, a red letter “M” will
appear in the screen of this channel. See “Alarm processes” in Section 2.5.1 for alarm
processing.
Operating prompt:
Remote controller operation: Use “
“ (display mode) to select full screen or blank;
Mouse operation: Left-click the mouse and drag the motion box to set the area of dynamic
detection.
For detailed operation procedures, please refer to the manual in the CD.
2.8 Network setup
Enter the “Network” screen from “Main Menu” →“Advanced” to “Network Setup”, as
shown below:
TYPE: with 4 options: STATIC, DHCP
、
PPPOE and 3G.