Monoprice PID 8743 Wireless N ADSL2 Modem and Router 802 11N WPS Function 2T2R 300Mbps - Manual (Page 68)

ADSL2/2+ Router
- 68 -
Router can automatically configure the IP addresses, subnet mask,
gateway and DNS server, etc for the computers that connect to the
router’s LAN ports and are configured to obtain an IP address
automatically. Therefore, it reduces the inconvenience and trouble in
manually configuring IP address and other network parameters for
multiple computers in LAN.

Enable/ Disable DHCP Server: Click the corresponding button to
enable/ disable the DHCP Server.

Start IP: The point from which DHCP server starts IP address
distribution.

End IP: The point where DHCP server ends IP address
distribution.

Lease Time: It indicates the valid time of the dynamic IP address,
which is distributed to the client’s host computer by DHCP server.
During this time, the server will not distribute the IP address to
any other host computer.
Note:
To use the Router’s DHCP server function, you must set the
TCP/IP protocol of the computers in LAN to “Obtain an IP address