American Audio DIGI-PRO - Manual (Page 25)

American Audio ® • DIGI-PRO™ INSTRUCTION MANUAL • PAGE 25
To FLIP-FLOP entire CDs:
To FLIP-FLOP an entire disc, be sure both drives are in continuous play mode. The
SINGLE ICON
(67) should not be displayed in the LCD (14) . When both drives are in continuous play mode, follow
the directions for single track FLIP-FLOP as detailed above. When one the disc in one unit ends the
other unit will immediately begin playback.
Combining FLIP-FLOP modes:
Flip-Flop modes may combined. One unit may run in single mode and the other in continuous mode.
When the units are arranged in this fashion, the unit in single mode will play a single track and flip to
the next unit. The next unit will then play the entire disc and flip back to the other. The other will then
play the next track and flip back to the other unit, and so on.
Fader Q-Start™
This function works in conjunction with a compatible American Audio “Q-Start" DJ mixer. When used
with a compatible CD player, you can use the crossfader to start and stop the CD Player with the slide
of the fader.
Connecting your DIGI-PRO to a Fader “Q” Start mixer for “Flip Flop” control: Be sure to connect
1/8” mini plugs from the control connection on the rear your DIGI-PRO to the 1/8” control jack on the
rear of American DJ “Q” series mixer. That’s it, you’ll be set for FLIP FLOP!
Scratch Box™ Compatible
The American DJ Scratch Box is a devices that simulates real time scratch of a CD. The Scratch Box
device is used in conjunction with any turntable and any Scratch Box compatible American DJ CD
player. For details of the Scratch Box refer to page 28.
ADVANCED OPERATIONS
Figure 35
FLIP-FLOP™
This feature is kind of “auto pilot." “Flip-Flop” mode can only function with the use of two DIGI-PRO
units. The “Flip-Flop” function may be used with or without an American Audio “Q” deck mixer, you can
have one unit begin playback when the other ends. You can “Flip Flop” single tracks, the entire disc,
a combination of the two, or you can even “Flip-Flop” your programmed tracks.
To FLIP-FLOP single tracks or programmed tracks:
1) Connect your system as described in the set up section on page 6.
2) Set your mixer’s crossfader to the center position.
3) Be sure your two units are single mode.
SINGLE (67) should be indicated in the LCD (14).
4) Load your two DIGI-PRO with audio disc.
5) After they have both cued, press the PLAY/
PAUSE BUTTON (29) on one of your drive to
begin playback.
6) After the first unit’s single track has ended the
second unit’s track will immediately begin play-
back.
7) FLIP FLOP will continue until you stop it or power
is interrupted.