Pure Highway 300Di - User Guide - Manual (Page 10)

8
Listening to Highway 300Di
Depending on how your unit has been installed, there are three possible methods for hearing Highway
300Di through your car stereo:
Auxiliary input Select the aux in source on your car stereo if Highway has been wired in as an
auxiliary source.
FM direct inject This method effectively takes over your FM source and replaces it with output
from Highway when you switch Highway on. Select the FM radio source on your
car stereo and tune to a particular frequency (default 87.6 MHz). Depending on
your installation this method may also retain access to your normal FM stations
to allow for traffic announcements and data services used by some navigation
systems. You can change this frequency in Settings, see page 15.
FM broadcast This method broadcasts the output from Highway over FM to your car antenna.
Select the FM radio source on your car stereo and tune to a particular frequency
(default 87.6 MHz). You can change this frequency in Settings, see page 15.
Selecting your audio source
Highway 300Di gives you a choice of available audio sources depending on your installation.
Choose from
Digital radio, USB (USB connection), iPod (USB connection) or Auxiliary input via
(3.5mm connection) as follows:
Press the
button and repeat to step through the source options until you see the one you want then wait
for a few seconds to select the source shown on the bottom line of the screen.
or
Press the
button and turn the Select knob to browse through the source options then press the
Select knob to select the source shown on the bottom line of the screen.
Digital radio
iPod
Changing source
(current source on top line)