Racing Electronics SC150 - Manual (Page 15)

7. Press
E
to store the entry. The frequency on the
display will blink twice to confirm the programming.
8. If that frequency is already stored in another
channel, you will hear a “beep”, and the other
channel number will appear on the display. If you
want to store the frequency in the selected channel
(18) as well, press
E
again. The frequency will
blink twice to confirm the programming. Or, you can
press .
twice and enter another frequency for the
currently selected channel.
Note: Any frequency already stored in any channel will
automatically be replaced by the new one.
9. If you try to enter a frequency that is outside one of
the 12 Bands, you will hear a “beep”, and the word
“Error” appears on the display.
Press
.
twice and re-enter the correct frequency.
10. To program another channel, repeat the above
procedures.
Deleting a Stored Frequency
To delete a frequency from a channel:
1. Display the channel and frequency that is to be
deleted.
2. Press
0
on the numeric keypad.
3. Press
E
. The current channel is erased, and the
display shows 000.000.
Note: That channel will be skipped during scanning.
B. Programming With SEARCH
The Search feature enables you to rapidly search for active
frequencies within the specified band limits. When an
interesting frequency is found, you can store it into a
channel using the procedure below. For more information
about SEARCH Mode, see the later section titled
“Searching”.
1. Press
N
to enter the SEARCH Mode.
15
C:...sc150om.vp
Wed Dec 17 10:24:25 1997
Color profile: Disabled
Composite Default screen