Rosendahl nanosyncs HD - Manual (Page 3)

- 4 -
3. Front Panel
S 1 L1 L2 L3 L4 L5 L6 L7 L8
(S1) Power Switch:
Switches the unit from standby power down mode to normal
operation mode and vice versa.
(L1) (L2) Video Reference:
The first four LEDs (L1) indicate the selected video reference.
INTERNAL, EXT.PAL, EXT.NTSC or EXT.TRI LEVEL.
The second column (L2) displays the detected frame rate.
(L3) SD Video Generator Standard:
The standard definition sync generator can be set to output NTSC,
PAL 25 or slow PAL 24 /23.98. The blue locked LED indicates that
the SD and HD video generators are genlocked to the selected video
reference.
(L4) (L5) HD Video Generator Standard:
The high definition TRI LEVEL sync generator can be set to generate
1080i/psf 1080p x1, 1080p x2, 720p x2 or 720p x1 standards
according L4. The LEDs (L5) indicate the selected frame rate.
(L6) SD/HD Select:
The six video outputs can be configured to output the SD or the HD
signal. VO1-3 (video outputs 1-3) are switched over together, outputs
VO4, VO5 and VO6 can be selected individually.
(L7) (L8) Audio Reference:
This field indicates the reference selection for the word clock and
AES/ SPDIF audio clock generator. Settings FOLLOW VIDEO, EXT.
WORD FS, EXT.WORD 1:1 and LTC FPS are possible under (L7).
Column (L8) indicates the selected frame rate for LTC FPS mode or
the sample rate (FS) selected when set to EXT.WORD FS mode.
- 5 -
L9 L10 L11 L12 L13 L14 S2 S3 S4
(L9) (L10) Sample Rate:
The base sample rate of the audio clock generator can be set to 44.1
or 48kHz. The blue locked LED indicates the audio lock status
according to the selected audio reference.
(L10) indicates applied word clock pull up or down rates: +4%
(25/24), +0.1% (1001/1000), -0.1% (1000/1001) or -4% (24/25).
(L11) (L12) (L13) Multipliers:
To generate double or quad sample rates (88.2, 96, 76.4, 192 kHz) it
is possible to apply x2 or x4 multipliers accordingly.
WO1-6 (word clock outputs 1-6) are configured according (L11) to
output x1, x2 or x4 rates. Outputs WO 7-8 can be set to x1, x2, x4 or
x256 (digidesign super clock) rates shown in column (L12).
AES and SPDIF reference signals can be configured to output Fs x1
or x2 sample rates.
(L14) USB Status, Config. Protect:
LED LTC to MTC indicates the translation of LTC time code into MTC
sent via USB to a connected host computer.
LED MMC/MTC to LTC signalises the operation of the internal LTC
generator controlled by a connected host computer using MMC or
MTC protocol or started
LED CONFIG.PROTECT indicates that the configuration protect
mode is activated.
(S2) (S3) (S4) Menu and Select Keys:
Use the Menu left and right keys (S2) (S3)(
◄ , ► ) to navigate through
the different fields. The parameters can be changed using the
SELECT key (S4). Press both menu keys (S2) (S3) to store all
settings to non volatile flash memory.