Rosendahl nanosyncs HD - Manual (Page 4)

- 6 -
4. Rear Panel
C1-C6 C7 C8 C9 C10 C11 C12-13
(C1- C6) SD/HD Video Sync Outputs (BNC):
Six video outputs VO1-VO6 are individually buffered to drive single
ended 75 ohm inputs. VO1-VO3, VO4, VO5, VO6 can be configured
to output standard definition sync signals or HD tri level reference
signals.
(C7) Video Sync Input (BNC):
Both internal video generators can be genlocked to external video
references using this input. The video sync input accepts SD
standard definition video syncs as well as HD tri level syncs
according to the selected video reference source. This input is
internally 75 ohm terminated and requires standard video levels.
(300mV Sync, 300 mV Burst, +/- 300mV Tri Level).
(C8) Word Clock Input (BNC):
The audio clock generator can be resolved to external word clock
signals. This input is internally 75 ohms terminated and accepts word
clock signals from 40-200 kHz at 1,5 - 5 Vpp levels.
(C9) LTC Time Code Input (RCA):
LTC time code (also called SMPTE) is read by the nanosyncs HD
and translated into MTC via the USB midi port. The audio clock
generator can also be resolved to the LTC applied on this input.
Timecode levels can vary from -40 to +20 dBu. This input is internally
terminated with 10k ohms (high impedance).
(C10) LTC Time Code Output (RCA):
The LTC time code output has a fixed output level of 1Vpp. It can
drive low impedance inputs down to 600 ohms. To connect to XLR
time code inputs a standard audio adaptor cable (RCA to XLR) is
required.
- 7 -
C14-C19 C20-C21 C22 C23
(C11) USB Port (USB type B):
A USB 2.0 midi device class compliant interface allows plug and play
connectivity to MAC or PC host computers (Operating systems
Windows-XP or Mac-OSX are required for the midi device class
functionality). Supports MTC and MMC as well as Rosendahl Sysex
commands for remote and update functions.
(C12- C19) Word Clock Outputs (BNC):
Word clock outputs WO1-WO6 can be configured to output base
sample rates (44.1/ 48 kHz) as well as x2 (88.2/ 96 kHz) or x4 (176.4/
192 kHz) rates. Outputs WO7-WO8 support x1, x2, x4 and also x256
(digidesign super clock) sample rates.
All outputs drive 3,5 Vpp into single ended 75 ohm inputs.
(C20- C21) AES/ EBU Outputs (XLR 3-pin):
Two AES-3 clock reference outputs can be configured to generate
standard x1 (44.1/ 48 kHz) or x2 (88.2/ 96 kHz) sample rates. These
outputs are transformer balanced and drive 3,5 Vpp into standard
110 ohm inputs.
(C22) SPDIF Output (RCA):
The IEC 985 SPDIF audio clock reference output can be configured
to provide standard x1 (44.1/ 48 kHz) or x2 (88.2/ 96 kHz) sample
rates. This output drives 0,5 Vpp into standard coaxial 75 ohm SPDIF
inputs.
(C23) Mains Socket (IEC):
Use the IEC mains cable supplied for connecting to an earthed mains
socket. Please see also page 4 "Unpacking…".