Sandvik Coromant Quick Change for CNC Lathes - Manual (Page 34)

34
TW-30-01
BT-TK-02
C-TK-01
C-TK-02
C-TK-03
C3*
C3
C4
C5
C6
C8
C10
5
8
10
12
12
12
17
5680 035-08
5680 035-05
5680 035-06
5680 035-07
5680 035-07
5680 035-07
5680 035-10
Accessories to be considered for
Quick Change
Torque Wrench
Always to be used for clamping and unclamping the cutting units in the machine and
the pre-measurement fixture. This is recommended to prevent any damage to the
cam shaft but also to ensure a consistent clamping force which is important to get
the most consistent repeatability. The correct clamping torque is marked on each
clamping unit.
Cover Plug
When you have clamping units in the turret and not in use,
always have a tool or cover plug clamped to protect the ground
surface of the polygon sleeve from dirt or damage.
• Cx-CP01
For manual clamping with segment clamping
• Cx-CP11 For NC3000 units using center bolt clamping
• Cx-CPA-01 For automatic tool change
When the clamping units are stored the plug should also be
clamped slightly. Ensure they are cleaned and greased to protect
them from rust.
Torque wrench
Coromant
Capto size
Key size
mm Key adaptor
* C3 Driven tools only
Cx-CP01
Cx-CP11
Cx-CPA-01