Sol Transit Shelter Ad Light - Manual (Page 13)

13 rev. 0512 MKTG-IM-TOLAR-TSAL-BACK TO BACK-003
Installation and Owner’s Manual | TSAL B2B Series
4. Carefuly remove the protective film on the back of the flexible solar array and secure on roof shelter by
gently pressing to adhere (Figure 15).
WARNING: Butyl adhesive coating is designed for first time adhesion and should not be
repositioned after adhering.
5. It is recommended that the PV harness be routed around shelter roof to upper section of ad kiosk
and excess harness be discretely secured by clips or other method to ensure a neat installation of
the ThinFilm panels(s) (Figure 16).
6. Alternately, a 7/8” hole can be drilled in shelter roof above upper light assembly to route harness
directly and secure opening with elbow seal tight. Routing around shelter and securing the excess
PV harness is the preferred method.
3.7 Installing ThinFilm on the Shelter Roof
1. Remove ThinFilm flexible solar array from packaging and place in desired horizontal surface of roof
shelter to determine correct positioning. Ensure that the panel is mounted on the surface most facing
towards the equator or due South in the Northern hemisphere.
2. Determine best route for PV harness to the upper section of the Ad Kiosk.
3. Connect flexible solar array MC type IV connectors to PV harness. Route PV Harness from shelter to
upper section of light assembly (Figure 14).
FIGURE 14 CONNECTING MC CONNECTORS
FIGURE 15 REMOVING PROTECTIVE FILM FIGURE 16 ROUTING PV HARNESS