AMX Distribution Matrix Octaire - Manual (Page 21)

Installation and Setup
17 Octaire Instruction Manual
Rack Installation and System Setup
Octaire Distribution Matrix enclosures fit in a standard EIA 19 in. (48.26 cm) rack (rack ears are
provided).
Important: The system requires at least one empty rack unit above and below the enclosure to
allow adequate airflow; three empty rack units are recommended.
Required items for rack installation:
Enclosure(s)
Rack ears
Standard EIA 19 in. (48.26 cm) rack
Screwdriver
Screws that fit your rack for mounting the enclosure(s)
Power cords (2 per enclosure)
Link cables (provided with multi-enclosure systems)
Surge-protectors – recommended
Optional items for rack installation
PC or laptop computer with a null modem cable (for communication with the Octaire via
the RS-232 serial port on the primary enclosure)
Installation Recommendations
Write the serial number for each enclosure (located on the rear next to the power receptacles)
in an easily accessible location before installing the Octaire in a rack.
Use earth-grounded power cords / system with the Octaire.
Attach all power cords to surge protector(s) and/or AC line conditioner(s).
Apply power to the Octaire enclosure(s) before applying power to its source and destination
devices.
Installation Procedure
A flow chart showing the installation sequence is in FIG. 7. The procedure, which follows on page 18,
provides general steps with references to detailed information found in later sections of the manual.
Caution: To prevent overheating and airflow restriction, avoid placing high heat-producing
equipment directly above or below the enclosure. The system requires a minimum of one empty rack
unit above and below (three empty rack units are recommended). Verify that the openings on the
sides of the enclosure are not blocked and do not have restricted air flow.
FIG. 7 Installation procedure