A.R.I. D-090P EN - Manual (Page 2)

2. Procedure For Maintenance of the Barak.
a) Gently remove the Outer cover (4) from the valve body (6) after
removing the Lock Pin (11).
b) Unscrew the Base (7) from the Body (6).
c) Check that the seal assembly (1) is not damaged and is free from debris and
wash with clean water. If the assembly is damaged or worn, replace it.
d) Wash the Valve Body (6) and the Float (8) with clean water and check both
for damage.
e) Wash the base (7) with clean water and check for damage.
f) Check that the entrance to the drain valve (9) is free from dirt or other
obstructions. Clean if necessary.
g) Reassemble the parts carefully in reverse order paying attention to the
condition of the all “O” rings (5) , (10) and (12) replacing if necessary. It is
recommended to lightly apply a thin film of a silicone based grease to the “O”
rings on reassembly.
Nick Levi- Technical Administrator R&D Department – A.R.I. Water Accessories, Kfar Charuv, Israel.
2