EarthQuake SWAT-2.4X - Manual (Page 11)

Transmitter
3.6 - 6V DC
Max 120mA
-15 - 65° C -15 - 65 C °
2400-2528MHz
GFSK
2 Mbps 2 Mbps
100kHz
One-way circulation
20 channels
4MHz
Open field range test was free from interference up to
100 meters.
20dBm; variable from 0dBm up to 20dBm
Max 1.0Vpk
10kΩ
Phono audio input
30mW RL=32Ω
50mW RL=16Ω
1kΩ
1:1
20Hz-20kHz
<0.5ms
65kHz at 16bit
95dB
4MHz
-90dB
20 channels
Two modes: Auto scanning
and manual selecting
100kHz
2400-2528MHz
Max 40mA
3.6 - 6V DC
Receiver
Work Voltage
Work Current
Operation Temperature
Practical Mode
Frequency Range
MODULATION
Band Rate
Frequency Stability
Selection of Channel
Practical Working Channel
Channel Space
RF Range
TX Power
RX Sensitivity
Input Level
Input Impedance
Input Interface
Stereo Output Level 1
Stereo Output Level 2
Output Impedance
Frequency Response
Latency
Sampling Ratio
S/N Ratio
THD
Dynamic Range
Channel Separation
Dimensions (L x W x H)
0.3%@1kHz
90dB
85dB
3.15” x 2.7” x 1” (80mm x 69mm x 25mm)
Gain ratio of output and input
Specifications 5 Year Limited Warranty Information
Earthquake warrants the original purchaser that all Factory Sealed New Audio Products be free from defects in
material workmanship, under normal and proper use, for a period of five (5) years from the date of purchase (as shown on
the original sales receipt with the serial number affixed/written on it).
The five (5) years warranty period is valid only if the product is properly installed by an Earthquake authorized
party, and the warranty registration card is properly filled out and sent to Earthquake Sound Corporation. If the product is
installed by a non-authorized party, a ninety (90) days warranty period applies.
(A) Five (5) years limited warranty plan coverage guidelines:
• First year: Earthquake pays for labor, parts, and ground freight (only in the U.S. mainland, not including Alaska
and Hawaii) back to the customer.
• Second year: Earthquake pays for labor and parts only, customer must pay freight both ways.
• Third, fourth, and fifth year: Earthquake pays for labor only. Customer must pay for parts and freight both
ways.
(B) Warning:
Products (sent for repair) that are tested by Earthquake technicians and deemed to have no problem, will not be
covered by the five (5) years limited warranty. Customer will be charged a minimum of one (1) hour of labor (ongoing
rates) plus shipping back to the customer.
(C) Earthquake agrees to repair or replace, at our option, all such defective products/parts subject to the following
provisions:
• Defective products/parts have not been altered or repaired by other an Earthquake factory approved
technician.
• Products/parts are not subjected to negligence, misuse, improper use, aor accident, damaged by improper
line voltage, used with incompatible products, or have its serial number or any part of it altered, defaced,
removed, or have been used in anyway that is contrary to Earthquake’s written instructions.
(D) Warranty Limitations:
Earthquake warranty does not cover products that have been modified and/or abused, including but not limited
to the following:
• Damages to unit cover and finish due to misuse, abuse, or improper use of cleaning materials/methods.
• Bent casing, damaged finish on casing due to abuse, misuse, or improper frame or broken connections.
• Fading, deterioration of components and finish due to improper exposure to elements.
• Burnt tracers of PCB.
• Product/part damaged due to poor packaging or abusive shipping conditions.
• Subsequent damage to other products.
A warranty claim will not be valid if the warranty registration card is not properly filled and returned to Earthquake with a
copy of the sales invoice.
(E) Service Request:
To receive product(s) service, contact Earthquake Sound’s service department at (510) 732-1000 and request
an RMA number (Return Material Authorization), item(s) shipped without a valid RMA number will be refused. Make sure
you provide us with your complete and correct shipping address, a valid phone number, and a brief description of the
problem you are experiencing with the product. In most cases, our technicians might be able to resolve the problem over
the phone, thus eliminating the need to ship the product.
(F) Shipping Instructions:
Product(s) must be packaged in its original protective box(es) to minimize transport damage. Shipper claims
regarding item(s) damaged in transit must be presented to the carrier. Earthquake Sound Corporation reserves the right
to refuse improperly packed product(s). A copy of original sales receipt must accompany product(s) returned for service.
We encourage you to include a written description fo the problem inside the package. Ship to:
Earthquake Sound Corp.
2727 McCone Avenue
Hayward, CA 94545 USA
You are responsible for the cost of shipping the product to Earthquake Sound Corporation.
(G) Disputes Resolution:
All disputes, between clients and Earthquake Sound Corporation, resulting from the five (5) years limited
warranty policy must be resolved according to the laws and regulations of the county of Alameda, California.
SWAT-2.4 Manual 10 Specifications are subject to change without notice. SWAT-2.4 Manual 9 Earthquake Sound Corp. | (800) 576-7944 | www.earthquakesound.com