EarthQuake SWAT-2.4X - Manual (Page 8)

SWAT-2.4 Manual 8 Specifications are subject to change without notice. SWAT-2.4 Manual 7 Earthquake Sound Corp. | (800) 576-7944 | www.earthquakesound.com
Connecting your SWAT 2.4
USB INPUT
CH Reset/Mute
Status
TRANSMITTER
USB OUTPUT
CH Reset/Mute
Status
RECEIVER
Sound Source
3.5mm Stereo to 3.5mm Stereo cord
Powered Subwoofer
or Powered Speaker
or Stereo Receiver
3.5mm Stereo to RCA cord
To connect your SWAT 2.4 Transmitter to
a sound source, such as an MP3 player,
computer, or stereo, use the Stereo to
Stereo cord or the Stereo to RCA cord.
Plug the Stereo jack in the “INPUT” of your
SWAT 2.4 Transmitter and plug the other
Stereo jack or RCA jacks into the output of
your Sound Source.
To connect your SWAT 2.4 Receiver to a
powered speaker/subwoofer, amplifier, or
stereo receiver, use the Stereo to RCA
cord.
Plug the Stereo jack in the “OUTPUT” of
your SWAT 2.4 Receiver and plug the
RCA jacks in the input of your speaker or
amplifier.
Connecting Your Transmitter
Connecting Your Receiver
Note: Each SWAT 2.4 unit has been
individually marked on its underside to
differentiate between the Transmitter and
Receiver.
USB INPUT CH Reset/Mute
Status
1) USB- USB power with a USB cable. Can plug in your computer's USB port for power using the computer to
supply power for the Transmitter. This feature is great for laptop users.
Note: USB CONNECTION WILL NOT CARRY SIGNAL. FOR POWER ONLY.
2) INPUT (or) OUTPUT- Stereo audio input or output with a 3.5mm stereo outlet.
3) CH- Channel Selection is used for pairing ID (On both the transmitter and receiver, hold the channel
buttons down at the same time for 3 seconds, until the LED light turns on. After you let go, the LED light will
flicker for 5 seconds, indicating that it is searching for the other unit. To connect to multiple receivers, hold
the button for longer than 3 seconds so it will keep pairing.)
4) Status- Light is on when unit is on.
5) Reset/Mute- Used when it is necessary to mute or reset the transmitter. Hold the button down and the
transmitter will mute. Press it once and the transmitter resets itself and restarts.
6) Power- Switch of Power. When power supply is connected through the USB input or DC input and the
switch is at OFF, the transmitter is turned off. When the switch is at ON, the transmitter is turned on.
DO NOT PLUG IN THE DC POWER SUPPLY AND THE USB POWER SUPPLY AT THE
SAME TIME. ONLY ONE POWER SUPPLY IS NECESSARY.
7) DC- DC power interface. Positive inside and negative outside; Voltage: DC 3.6 – 6V
8) ANT- 2.4GHz antenna. The antenna can rotate 180 degrees. However, do not rotate past resistance.
Earthquake Sound is not liable for antennas broken in this manner.
Interface
ANTENNA
POWER
OFF ON 5VDC
SWAT 2.4
+
–
1 3 4
5
6
7 8
2