Alpine CDA-7846E - Manual (Page 44)

44
English
CD Shuttle Operation
Multi-Changer Selection
Alpine’s Ai-NET system will support up to 6 CD
Shuttles. When operating two or more
changers, the KCA-400C (Multi-Changer
Switching device) must be used. If you use 1
Switching device, you can connect up to 4 CD
Shuttles. If you use 2 Switching devices, you
can connect up to 6 CD Shuttles.
Press the SOURCE button on the CDA-7846E
to activate the CD Changer mode.
Alternatively, press the SOURCE button on the
Remote Controller (RUE-4185) to activate the
CD Shuttle mode. Proceed to Step below to
select the desired CD Shuttle.
Press the BAND button on the CDA-7846E or
the RUE-4185 to activate the CD Shuttle
Selection mode.
The CD Shuttle Selection mode remains active
for 3 seconds after Step is performed. Press
the BAND button until the desired CD Shuttle
indicator appears on the display.
Note: If the selected CD Shuttle is not con-
nected, the display will show "No
Changer X".
1
2
3
SOURCE
BAND
T.S.M.
BAND
T.S.M.
Changer-X
Remote Control
RUE-4185
BAND
PROG SOURCE A.PROC
SOURCE