bloom zen - Manual (Page 14)

2
eng
through the opening on backrest.
– Pass end of the crotch strap through the two
openings in the seat, then pass through the
lower opening on backrest to the rear side.
(refer to illustration 4)
– Connect crotch strap end to frame anchor
strap by threading the fabric loop on anchor
strap to the metal ring. (refer to illustration 5)
– Please make sure harness buckles are in
correct orientation.
To install seat
– Slide the two plastic guiders on either sides
of backrest into the grooves of seat frame
simultaneously all the way to the bottom.
(refer to illustration 6)
– Fasten the two elastic loops on either side
of backrest to the handlebar pivots. (refer to
illustration 7)
– Tug plastic guide on the front edge of seat
fabrics under seat base. (refer to illustration 8)
– Fasten the two buttons on the front side of
seat to footrest. (refer to illustration 8)
– Mount seat fabrics onto stroller seat base by
fastening the three elastic loops onto plastic
hooks located under seat base. (refer to
illustration 9)
– Fasten the elastic on the end of anchor strap
to the plastic hook located under seat base.
(refer to illustration 9)
To attach seat cushions
– (#03 – seat cushions) Place back cushion
on backrest and seat cushion on seat base.
(refer to illustration 10)
– Pass the two shoulder straps through upper
openings and the waist straps through lower
openings of back cushion.
– Pass crotch strap through opening of seat
cushion. (refer to illustration 11)
To install basket
– (#04 – basket) Thread the two elastic loops
on basket through slots located at the back
of the frame’s central node, then fasten onto
catches. (refer to illustration 12)
– Fasten all snap buttons on the basket to
chassis. (refer to illustration 13)
– Use strap underneath the basket to secure
brake cables. (refer to illustration 13)
To install canopy
– (#05 – canopy, #06 – canopy ribs) Insert the
two plastic ribs through channels in canopy
fabric. (refer to illustration 14)
– (#07 – canopy adapters) Insert ends of the ribs
into canopy adapter slots and attach elastic
loops to the reels. (refer to illustration 15)
– Slide canopy adapters onto connectors
located on both sides of seat frame. (refer to
illustration 16)
– On the back of the canopy, fasten the three
snap buttons and fix the four velcro on
canopy to the backrest. (refer to illustration 17)
Section B: On Usage
To use canopy
– The canopy can be adjusted to 3 positions:
retracted, half opened, fully opened. Make