bloom zen - Manual (Page 15)

3
eng
press button marked with a road light sign.
(refer to illustration 23)
To brake
– (m – parking brake pedals) To engage parking
brakes, push down either left or right pedal.
– To disengage parking brakes, push up either
left or right pedal. For safety, lock parking
brakes when placing or removing your child,
or when installing accessories. (refer to
illustration 24)
To fold
– Unhook the two elastic loops on handlebar
pivots and pull down the two zippers
completely. Fold down upper part of backrest
along with canopy. (refer to illustration 25)
– Hold loose fabrics and seat cushions in place
by connecting the elastic strap under seat to
elastic strap on the back of backrest. If folding
without canopy on, hold loose fabrics in place
by connecting the elastic strap under seat
direct to the catch on the back of backrest.
(refer to illustration 26 & 27)
– Simultaneously press the two buttons at the
center of handlebar, and rotate handlebar
down all the way. (refer to illustration 28)
– (a – front handle, n – anti-slip stopper) Using
front handle, rotate stroller frame, so that the
back wheels and anti-slip stoppers are on the
ground. (refer to illustration 29)
– Standing on the seat frame side, push the white
unlocking lever outward then hold bottom of
footrest and lean the seat frame towards you,
until seat frame is leaning approximately 30
sure the button on top of the canopy is
undone before fully opening canopy. (refer to
illustration 18)
To use and adjust safety harness
– To lock harness, push the tongues on ends
of waist straps, connected with the ends of
shoulder straps, into the buckle on crotch
strap.
– To unlock harness, press the central button.
(refer to illustration 19)
– NOTE: Every time you place your child in the
stroller or whenever you alter the position
of the seat, always check that the harness
is correctly fitted. Tighten harness until it fits
snugly around your child.
To recline backrest
– (i – seat recline zippers) Unzip the pair of
zippers on both sides of backrest for half
recline position. (refer to illustration 20)
– Unzip the inner pair of zippers for full recline
position. (refer to illustration 21)
To use headlight
– (o – lighting system main power button) To
turn lighting system power on, press button
located underneath the frame’s central node.
Press again to turn off. (recommended after
each usage). (refer to illustration 22)
– (h – warning light button, g – driving light
button) To use warning light, on handlebar,
press button marked with parking light sign
(triangle). To use driving light, on handlebar,