Aiwa AV-NW50 - Manual (Page 11)

En
ENGLISH
11
BASIC OPERA
TIONS
TO CHANGE A DISPLAYED NAME FOR
THE VIDEO 1 AND VIDEO 2 FUNCTION
When the VIDEO 1 function is selected, VIDEO 1 is displayed
initially. It can be changed to MD.
While pressing ENTER, press INPUT MODE.
The displayed name for the VIDEO 2 function can be changed to
VIDEO 2, LD or TV. Select VIDEO 2 function.
While pressing ENTER, press INPUT MODE.
TO SELECT "ANALOG" OR "DIGITAL"
MODE OF THE DVD, VIDEO 1 OR VIDEO 2
FUNCTION
Select DVD, VIDEO 1 or VIDEO 2 function and press INPUT
MODE repeatedly so that the desired mode "
❅▼❅❑◆❋ " or
"
❈❍❋❍❙❅❑
" is displayed.
In DIGITAL mode: Equipment connected to the DIGITAL IN
OPTICAL (DVD) terminal is selected as a source for the DVD
function, equipment connected to the DIGITAL IN OPTICAL
(VIDEO 1) terminal for the VIDEO 1 function, and equipment
connected to the DIGITAL IN COAXIAL (VIDEO 2) terminal for
the VIDEO 2 function.
In ANALOG mode: Equipment connected to the DVD terminals
is selected as a source for the DVD function, equipment
connected to the VIDEO 1/MD terminals for the VIDEO 1 function,
and equipment connected to the VIDEO 2/LD/TV terminals for
the VIDEO 2 function.
WHEN THE "OVER LEVEL" INDICATOR
LIGHTS UP
When input analogue signals from the connected equipment are
too high to accept, the
◆❯❉◗✤❑❉❯❉❑
indicator lights up. In this
case, adjust the input level so that the indicator disappears.
To adjust the sound level of the connected source
When the analogue sound level of the connected source is higher
or lower than that of the FM and AM functions, adjust it as follows.
1 Select the function to be adjusted.
Turn FUNCTION and play the source.
2 Press TUNING M or N repeatedly.
The level changes as follows.
–6 dB 0 dB +6 dB
SELECTION OF AUDIO/VIDEO
SOURCE
FUNCTION FUNCTION
ENTER
TUNING
INPUT MODE
TV/VIDEO
INPUT
MODE
JOG
- , +
1 Turn FUNCTION to select the program source.
The function changes in the following order.
FM AM DVD CD AUX
TAPE VIDEO 1 5.1ch IN VIDEO 2
The actual source selected (except FM and AM) depends on
the equipment connected to the input terminals on the rear
panel of the unit.
For example, if an MD player is connected to the VIDEO 1/
MD terminals, select VIDEO 1 to listen to the MD playback
sound.
To select with the remote control
Press FUNCTION repeatedly.
2 Start the selected program source.
3 Adjust the sound.
SELECTION OF VIDEO SOURCE
While selecting a program source which does not contain video
input (such as a CD player), you can select a video source
separately to be viewed on the TV.
1 Press FUNCTION repeatedly to select FM, AM, CD,
AUX, TAPE or 5.1ch IN.
2 Press TV/VIDEO.
3 Press JOG + , - repeatedly.
The video source to be output through the MONITOR VIDEO
OUT jack changes in the following order.
M-OUT V1 M-OUT V2 M-OUT DVD
▲✱◆❚❙✤❯✵ : Video image of the equipment connected to the
VIDEO 1/MD terminals can be viewed on the TV.
▲✱◆❚❙✤❯✶ : Video image of the equipment connected to the
VIDEO 2/LD/TV terminals can be viewed on the TV.
▲✱◆❚❙✤❈❯❈ : Video image of the equipment connected to the
DVD terminals can be viewed on the TV.
BASIC OPERATIONS