Aiwa AV-NW50 - Manual (Page 18)

18
ENGLISH
TO LISTEN TO THE ORIGINAL DTS
SOUND
When " ❝sr " appears on the display, all the sound settings can be
cancelled.
Preparation
Play a disc recorded in DTS surround.
1 Press ENTER.
" ❆❳❖❅❘❘✤◆❊❊ " is displayed.
2 Press ENTER again so that "
❆❳❖❅❘❘✤ ◆▼
" is
displayed.
To restore the sound settings
Repeat steps 1 and 2 so that " ❆❳❖❅❘❘✤◆❊❊ " appears.
To operate with the remote control
Hold down SHIFT and press MIDNIGHT repeatedly.
ADJUSTING THE SOUND OF DOLBY PRO
LOGIC II MUSIC MODE
In Dolby Pro Logic II Music mode, press MANUAL SELECT
repeatedly to select one of the adjusting modes (PANO, DMSN
or CTR W). Then press JOG
+ or - to turn the mode on or off,
or select the level.
Panorama mode (PANO): Expands stereo effect of the front
speakers toward the rear sound field and enhances "surrounded"
stereo effect.
Dimension mode (DMSN): Adjusts the level to move the broad
sound field to the front side (F) or rear side (R). The level changes
as follows:
R+3 R+2 R+1 F+1 F+2 F+3 OFF(normal)
Centre width mode (CTR W): Redistributes centre speaker's
signals to the front speakers.
OTHER SETTINGS
MIDNIGHT
ENTER
MULTI JOG
SHIFT
MANUAL
SELECT
JOG - , +
ADJUSTING LOW FREQUENCY SOUND
EFFECT (LFE)
The disc recorded in Dolby Digital surround contains special
signals called LFE to enhance low frequency sound effect.
The LFE signals are recorded in some particular parts on the
disc and output from the connected sub woofer to reproduce
astonishingly powerful low sound.
The sound level of the LFE signals can be adjusted according to
your speakers.
Preparation
Play a disc recorded in Dolby Digital surround.
1 Press MANUAL SELECT on the remote control.
" ❑❊❉ " is displayed.
2 Press JOG + or - to adjust the LFE level.
The unit is initially set to 0 dB (maximum) and can be adjusted
as follows:
OFF –10 dB –5 dB 0 dB
MULTI JOG on the unit is also available.
When selecting " ❘✱❱✤◆❊❊ ", the LFE signals are redistributed to
other speakers.
ADJUSTING DYNAMIC RANGE
Dynamic range of the sound can be adjusted. The unit is initially
set to "
❘❙❈ " (standard) mode.
Preparation
Play a disc recorded in Dolby Digital surround.
1 Hold down ENTER (hold down SHIFT and press
MIDNIGHT).
" ▲❍❈✤▼❍❋●❙✤❙●❉❅❙❉◗ " runs through on the display.
2 Turn MULTI JOG (press JOG + or - ) to select
" ▲❍▼ ", " ▲❅❲ " or " ❘❙❈ ".
▲❍▼
: You can enjoy the full dynamic range of sound like in the
movie theatre.
❘❙❈ : Original position, when playing back in home, that is
recommended by the software producers.
▲❅❲ : Select this mode when playing back at low volume.