Arcam AVR Surround Amplifer AV888 - Manual (Page 58)

E-56
Continuous power output (20Hz—20kHz at 0.05% THD), per channel
(AVR600 only)
2 channels driven
150W
All channels driven 120W
THD at full rated power <0.2%
Residual noise & hum <0.25mV unweighted 20Hz – 22kHz
Inputs
Phono input:
Input sensitivity at 1kHz
5mV
Input impedance 47kΩ
Signal/noise ratio (CCIR, 65W) 88dB
Overload margin 31dB
Line inputs:
Nominal sensitivity
500mV–4V (user adjustable)
Input impedance 47kΩ
Signal/noise ratio (CCIR, 65W) 100dB
Preamplifier outputs
Max output level
6V RMS
Output impedance <50Ω
THD+N (20Hz—20kHz) -100dB
Video inputs
Component video signal/noise
85dB
Composite video signal/noise 70dB
Headphone output
Maximum output level into 600Ω
4V p-p
Output impedance <5Ω
Continual improvement policy
Arcam has a policy of continual improvement for its
products. This means that designs and specifications
are subject to change without notice.
specifications
General
Mains voltage
110–120V or 220–240V
Power consumption (maximum)
AVR600
1.5kVA (Thermal dissipation approx.
2300 BTU/hour)
AV888 120VA (Thermal dissipation approx.
410BTU/hour)
Power consumption (idle, typical) 120VA (Thermal dissipation approx.
410 BTU/hour)
Power consumption (standby) 3VA
Dimensions W x D x H (including feet) 432 x 450 x 180mm
Weight (net)
AVR600
25.0kg
AV888 12.0kg
Weight (packed)
AVR600
28.0kg
AV888 17.0kg
Supplied accessories Mains lead
CR102 remote control
4 x AAA batteries
Manual
HDMI lead support bar
DAB aerial (if DAB module fitted)
FM aerial (if AM/FM fitted)
AM loop aerial (if AM/FM fitted)
Calibration microphone
E&OE
NOTE: All specification values are typical unless otherwise stated.