Red Lion TCU - Manual (Page 48)

Reference Table: Configuration Parameter Module
Configure Module 1 - Input Parameters (1-IN)
Display Parameter
Range and Units
(Factory Setting
Value)
Description/
Comments
tYPE Input type tc-t - Type T TC
tc-E - Type E TC
tc-J - Type J TC
tc-k - Type K TC
tc-r - Type R TC
tc-S - Type S TC
tc-b - Type b TC
tc-N - Type N TC
LIN - Linear mV
display If changed, be sure to
set the internal jumper
to the appropriate
position.
(jumper in TC
position)
r385 - 385 curve RTD
r392 - 392 curve RTD
rLIN - Linear ohms
display
(tc-J)
(jumper in RTD
position)
SCAL Temperature
Scale °F/°C
( °F)
If scale is changed, be
sure to check all
parameters.
dCPt Temperature
resolution 0 or 0.0
(0) If resolution changed,
be sure to check all
parameters.
FLtr Digital filtering
for input
signal 0 to 4
(1) Increase number for
more filtering effect.
4 = 2/sec display
update rate.
SPAN Input signal
slope
(correction
factor) 0.001 to 9.999
(1.000) Normally set to 1.000.
SHFt Input signal
offset
(correction
shift) -999 to 9999
1 or 0.1 degree
(0) Normally set to 0.
SPLO Lower limit
setpoint range -999 to 9999
0 or 0.1 degree
(0) Set low limit below
high limit.
Display Parameter
Range and Units
(Factory Setting
Value )
Description/
Comments
SPHI Upper limit
setpoint range -999 to 9999
1 or 0.1 degree
(9999) Set high limit above
low limit.
SPrP Setpoint ramp
rate 0.0 to 999.9
degrees/minute
(0.0) 0.0 is off (no ramping)
This parameter also
ramps Remote
Setpoint.
InPt User input PLOC - Program
disable
ILOC - Integral action
on/off
trnf - auto/manual
select
SPrP - Setpoint ramp
rate on/off
ALrS - Reset alarm
output(s)
Prnt - print request
SPSL - Remote/Local
Setpoint select
(PLOC)
Available on all
nonstandard models
and on standard
models with RS485.
HCur Heater
Current
Monitor
Scale Factor 0.0 to 999.9 amperes
(50.0) Scale to current
transformer rating.
40