ARI Armaturen CONA control EN - Manual (Page 4)

Page 2-4 Rev. 0040807014 1614
Operating and Installation Instructions
CONA
®
-control
3.0 Storage and transport
- Store the device in a dry, dirt-free location (temperature range: -40°C to +85°C.
- Don't remove the electronics, valve or measuring amplifiers from the packaging until they
are actually ready to be installed.
- The paint is a base coat to protect against corrosion during transport and storage. Be
careful not to damage the paint protection.
- Don't soil or damage the rating plate or the circuit diagram.
4.0 Description
4.1 Applications
The CONA
®
-control monitoring system is a test device for steam traps. A test chamber is
installed either directly in front of or on the steam trap. Steam leakage or blockage of the
steam trap can be detected by means of a sensor.
Detected faults can optionally be grouped together and indicated centrally, for example in
the control room. Relay outputs or an AS-Interface are provided for data communication.
The AS-i master has an interface for higher-level bus systems, so that fault indications can
also be directly evaluated by the plant controls.
All information provided here conforms to the Pressure Equipment Directive 97/23/EEC.
It is the responsibility of the plant planner to ensure compliance.
Special markings on the valve must be taken into account.
Refer to the data sheet to see which materials are used in standard versions.
Please contact the supplier or the manufacturer if you have any questions.
ATTENTION !
- Protect against external shocks (impact, vibration, etc.).
- Valves must not be used to absorb external forces, e.g. they are not designed to
be used as climbing aids or as attachment points for lifting gear.
- Suitable handling and lifting equipment must always be used.
Refer to the data sheet for weights.
ATTENTION !
- Refer to the data sheet for applications, limits of use and operating options.
- Certain media require or preclude the use of special materials for the test
chambers.
- The valves are designed for standard operating conditions. If the actual
conditions exceed these requirements, e.g. aggressive or abrasive media, all
non-standard requirements should be indicated in the order.