Acura 08P34-SEC-2001-81 - Manual (Page 3)

3
USING THE CAR COVER CABLE AND LOCK
Install the cable and lock as shown in the illustration. The locking system will be
ineffective if the cable is incorrectly installed.
The cable must be threaded through the loop on one end and locked to itself at the
other end as shown (see figure D). The steel cable passes under the car and through
the scratchproof grommets at the bottom of the sides of the cover. The cable is
secured with the lock. The cover may be used with or without the lock and cable.
CLEANING AND WASHING INSTRUCTIONS
NOTICE: Do not dry this cover in automatic dryers.
The cover can be washed while it is on the car with a small amount of Liquid
Fantastik Cleaner and a soft brush or sponge. Use water to completely rinse off the
cleaner. Leave the cover on the car, or draped over a clothes line or wall, and allow it
to air dry.
The cover can also be washed in a large automatic washer found in most commercial
laundromats. A home-sized washer is too small. DO NOT use a washer with an
agitator as this can rip or tear the fabric. Use two (2) cups of Liquid Fantastik
Cleaner. DO NOT use soap or detergent. The cover can be washed in warm water.
Water temperature must not exceed 185°F (85°C)
Run it through two rinse cycles. It is very important that the cleaner is thoroughly
removed to preserve the cover’s water repellency.
Do not put the cover in an automatic dryer — severe damage to the cover will
occur. The cover can only be air-dried draped over a clothes line, wall or on the car.
DRIVER’S SIDE
OF COVER
LOCK
KEY
CABLE PASSES
UNDER CAR
PASSENGER SIDE
OF COVER
FIGURE D