AMETEK 1025 Foot & Palm Switches User Manual
Page 8
Chapter 2: Unpack & Set-up
Operating Manual
4
11.
Change the TIME UP/TIME DOWN switch to the TIME UP position and start
with the cable rewound. The Safetimeter will begin to count when the 20 inch
CSP setting is reached and continue until the cable stops or the direction is
reversed.
12.
Set the CSP dial to several values and check that the Safetimeter begins to
count at the preset positions when the cable is moving in the direction selected
by the TIME UP/TIME DOWN switch.
13.
If the optional Manual Start Switches are available, continue with steps 14-15.
If not, move to Chapter 3: Operating Instructions.
14.
Plug one of the Manual Start Switches in the MANUAL Start jack. If the
Safetimeter is ON, the counter will begin to run. Switch the Safetimeter OFF
and then ON to reset the counter.
15.
If the Manual Start Switch is normally closed (red plug), the Safetimeter will
begin to count when the switch is pushed. If the Manual Start Switch is
normally open (black plug), the Safetimeter will begin to count when the switch
is released.