AMETEK 2110 Shut Height Monitor - Manual (Page 48)

Installation and Programming Manual 44
Chapter 4: Programming
45 Installation and Programming Manual
Chapter 4: Programming
REPLACE “X” WITH SLOT LOCATION
Analog Output Channel 1
A) Select voltage or current output
1. Select the function key.
The monitor displays “F-----”
2. Enter function number X04. Select the enter key.
The monitor displays the current function value.
0 = voltage output
1 = current output
3. Leave current value or change. Select enter key.
X04
Enter
0 or 1
8
(F)
8
4.6: Analog Outputs
The Analog Output board provides two channels of analog output that can be independently
configured and scaled. Each channel can be configured for an output based upon position.
Each of the two analog output channels generate a simultaneous voltage and current output.
You can use either the current or voltage output on one channel but not both.
The following programming sequences require that you specify your intent to use either the
voltage or current output for each channel prior to programming the output scaling. You can
configure one analog channel for use of its voltage output and configure the other channel for
current.
The analog output board will be factory installed in slot 2 or slot 4 of the Series 2110 module’s
chassis. Look at the back of your Series 2110 module and verify which slot your analog output
board has been installed in. The following programming function numbers are shown with an
“X” as the first digit. The “X” must be replaced with the number 2 or 4 which corresponds to
the slot in which your analog output board was installed at the factory.
NOTE: Boards cannot be changed from their factory supplied slot location in the field.
It is recommended that you configure and program the analog output in the following sequence.
Perform all programming steps for one output channel before proceeding to the other output
channel.
T13692 Chapter 4.indd 3/17/04, 6:50 AM 44