High Country Tek Plug Top Driver Series - Manual (Page 7)

Electronic Controller Solutions for the Fluid Power Industry
Mechanical Data:
NOTE:
Controller interfaces with industry standard
DIN 43650 - 3 pin connector as shown
Severe Environment Application Guide:
Liquid tight cable
outlet
Rubber gasket seal in
lid recess.
Driver plug base
to valve coil
rubber gasket
supplied ( loose )
M3 x 40mm mounting
screw
If required, Apply
‘lithium grease’ under
lid ( fill ) and between
driver plug base,
gasket and valve coil
connector.
For ‘high moisture’ applications apply ‘lithium grease’ between valve coil and driver plug base before final assembly and mounting
screw tightening process.
For total immersion applications, follow above step and additionally fill driver plug lid with ‘lithium grease’ after adjustment and
before final assembly to form liquid proof seal around all potentiometers and units plug base / valve coil joint.
Refrain from high pressure washing that enables liquids to get between the PTD and the coil connector.
Wherever possible, mount valve and PTD
so that debris or liquid will drain away or off
the surface.
Mount PTD so that liquid tight cable exit
gland is facing down or away from the
direction of debris or liquid flow.
Use care when re-assembling unit after
adjustment and ensure that lid gasket is in
place. DO NOT over tighten the central M3
x 40mm mounting screw.
Ensure that flat rubber gasket
( supplied ) is fitted between valve coil
and driver plug.
Housing Type:- Self contained DIN ‘Plug Top’
Housing Material:- High Impact Resistant Molded ABS.
Housing Colour:- Black / dark Grey.
Surface Finish:- Matt.
Housing Thickness:- 2mm ( Mounting Flange and Face ), 1.7mm All Internal Dividers.
Lid material:- High Impact Resistant Molded ABS.
Lid Colour:- Opaque clear.
Lid finish:- Matt.
Unit size:- See above size detail drawings.
Unit Weight:- Approx.... 400 grams ( including Encapsulation material & Cable )
Wire entry:- Pre-wired and sealed via PG11 gland to fixed cable.
Encapsulation:- Flame Resistant, Black , Two Part Epoxy Resin.
Wire length:- Approx...... 3 Meters colour coded cable
Wire specification:- 4 core, 16/02 with PVC outer protection to Def Standard 16-12 Part 5
( Screened ) 2.5 Amps/core @ 70°C Max Operating Temperature.