Power Bright APS300 - Manual (Page 4)

Installation
The inverter has to be installed in a dry and clean place not
being exposed to humidity.
Make sure there is proper ventilation.
Keep at least a free space of 10 cm surrounding the inverter.
If installed into housing, make sure there’s good ventilation.
The air intake on the bottom of the inverter and the air outlet on
the back side may not be blocked.
In case of ambient temperatures of more than 35C (e.g. engine
or heating room, direct sunlight), the inverter will switch off
automatically, because of self heating effects during operation.
The installation surface must be balanced and sufficiently
strong.
Installation of the inverter
-Adjust the inverter to the chosen installation place and mark
the fixing points.
-Fix the inverter by using the self chosen fixing method.
Electrical connection
General instructions for electrical connection.
In case of the inverter is installed into vehicles or boats it has to
be connected to the chassis (ground).
If cables have to be inserted to metal walls or other sharp-
edged means, use a cable duct or cable bushes.
Do not pull the cables.
Do not lay cables loose or in sharp bends on electrical
conducting materials (metal).
Do not lay 110V mains cable and 12/24 VDC cable together
into the same cable duct.
The specified minimum cable cross section must be complied
with.
Secure cables properly.
Lay cables in such a way that no tripping is possible.
Lay cables in such a way that no exposure to or risk of damage
is possible.