Trouble shooting – OZ Lifting Products OZ Builder's Hoist OM User Manual
Page 11
Trouble Shooting
If the hoist fails to start after several attempts or the hoist’s operation appears to
be defective check the following:
OBSERVED
ANOMALY
POSSIBLE CAUSE
SOLUTION
No Reaction
after
pressing the
buttons on
the control
pendant
No power
Check power source
Disconnection of plug, power cord or pendant cord
Replace or repair
Damaged motor resulting from overload
Replace
Burnt diode assy
Replace
Considerable voltage drop
Adjust to rated voltage
Wearing of carbon brushes
Replace carbon brushes
Brake
distance too
long
Wearing of lining, pressed plate and pawl
Replace
Disconnection of electronic generated braking
Repair nut cord or Replace D type resister
Voltage Too high
Adjust to rated voltage
No overwinding
Prevention
while swivel
hook
touches
limit lever
Disconnection of electronic generated braking
Repair nut cord or Replace D type resister
Malfunction of limit switch
Replace
Lifting
speed too
slow
Overload
Reduce Load
Considerable voltage drop
Adjust to rated voltage and check the section of the
power cord
Electrical
leakage or
shock
Burnt motor resulting from overload
Replace motor
Wearing of carbon brushes
Replace carbon brushes and clean any carbon powder
in the motor
Water invaded motor or push button
Dry it or replace motor if badly saturated
Abnormal
sound in
gear box
Insufficient oil resulting from oil leakage
Replace oil seal and refill with sufficient oil
Distortion of gear box
Repair
pg.11
All mechanical or electrical work must be carried out by a qualified tradesperson.