Bloom Manufacturing 2200 Series - Manual (Page 4)

(b) the product has been subject to careless or negligent misuse, damage or use of improper oil while in the possession of the
purchaser or any person to whom the product was transferred by the purchaser or was installed or operated other than in
accordance with the manufacturer's operating instructions.
(c) the product was used with accessories not recommended by Bloom Mfg. Inc. or for loads in excess of those listed as rated
for the product.
(d) in the case of hydraulic motors, Bloom Mfg. Inc. will not accept responsibility and warranty will be subject to manufacturer's
warranty.
The ninety (90) day limited warranty period shall commence with the date the product is sold to the purchaser by the dealer or
if this date cannot be established, the date the product was sold by Bloom Mfg. Inc. to the dealer.
The implied warranties of merchantability and fitness for particular purpose are limited to the duration of this warranty - ninety
(90) days - after said (90) days, Bloom Mfg. Inc. expressly disclaims any warranty or merchantability or fitness for any
particular purpose
particular purpose.
Purchase or other acceptance of the product by the claimant shall be on the condition and agreement that Bloom Mfg. Inc.
shall not be liable for incidental or consequential or contingent damage, secondary charges or loss or expense resulting from
any alleged defect, failure of article to operate properly, or for the negligence of others or damages of any kind.
Bloom Mfg. Inc. is not responsible for the cost, of removal of product, damages due to removal or any other expenses
incurred in shipping the product to or from Bloom Mfg. Inc. or the installation of the repaired or replacement product. The
t b th consumer must bear these expenses.
To make a claim under this warranty, write directly to Bloom Mfg. Inc., Independence, Iowa 50644, identifying the product and
giving its location and follow the company's return instructions which will be provided by the company. Bloom Mfg. Inc. will
make its best efforts to repair or replace the product, if found to be defective within the terms of this warranty, within sixty (60)
days after return of the product to the company.
This warranty is exclusive and in lieu of all other warranties whether written, oral or implied (including any warranty of y , p ( g y y
merchantability or fitness for a particular purpose.
ƒ Make sure that the hydraulic hoses have been disconnected
Section 3 Maintenance & Repair
CAUTION
ƒ Make sure that the hydraulic hoses have been disconnected
before servicing unit
A Speed Reducer, like other types of machinery, needs to have regular maintenance if it is to perform properly, give lasting
value, and provide safe operation.
value, and provide safe operation.
(a) Clean and Inspect
Thoroughly clean all of the parts in a good grade of cleaning solvent; one that is not flammable, not toxic and will not
cause skin rashes. If necessary, use rubber gloves. Inspect all parts for wear, nicks, scratches and damage that would
render them unusable. If a part is questionable, it is better to replace it rather than take a chance on premature failure
when the Speed Reducer is placed back in service. Always replace O-rings and seals, and it is a good idea to use new
roll pins as well. Sometimes it is permissible to reuse bearings and bushings...it depends on how much use they have
Think S-A-F-E-T-Y First Bloom Mfg Inc. 319-827-1139 4
p p g g p y
had. The ball bearings should not exhibit any surface irregularities. If the ball bearings show any sign of spalling,
corrosion, discoloration, material displacement or abnormal wear, the bearings should be replaced. If the Speed Reducer
was disassembled only to replace damaged seals after a short period of service, it is not necessary to replace the
bearings.
Page 4 of 6