Summers 50' Superroller - Manual (Page 17)

SECTION 2 - ASSEMBLY
2-7
H1. Install Hydraulic components as shown.
a. Leave enough slack at hitch pivot to allow folding machine without stretching or pinching
hydraulic hoses.
b. Secure with nylon ties and clamps provided. Do not over tighten clamps.
H2. Block hydraulic cylinders so rods can extend 32” without contacting any obstructions. Fully
extend and retract cylinders 3 times to insure all air is purged from system.
H3. Connect Rod End of Center Tilt Cylinder to Center Clevis as circled in P-H1 and P-H2.
P-H1 P-H2
P-H3
WING LOCK
HYD. VALVE