Summers 53' Trail-Type Superroller - Manual (Page 29)

SECTION 3 – OPERATION
3-5
TRANSPORTING LAND ROLLER:
1. If Land Roller is in Field Position, follow “Steps Required to Fold Land Roller from Field to Trans-
port Position”, page 3-4.
2. Ability to safely operate the Summers Superroller is determined by both tractor horsepower and
weight. The minimum tractor weight for operating this implement is 20,000 lbs. Minimum tractor
engine horsepower is 180. Dual tires or single tires set at maximum width are required for safe
operation of Land Roller.
3. ONLY TOW at a safe speed – 20 MPH MAXIMUM. Use caution when making corners or meet-
ing traffic.
4. USE Safety Lights and Safety Chain between tractor drawbar and implement hitch when trans-
porting on public roads.
5. ALWAYS install lift cylinder locks.
6. FOLLOW ALL local laws governing transporting of farm machinery.
7. Use additional caution and reduce speed when towing under adverse conditions, when turning
and when on unlevel surfaces.
8. Stay clear of overhead lines and other overhead obstructions.
9. Frequently check for traffic from rear, especially during turns.
UNHOOKING LAND ROLLER FROM TRACTOR IN FIELD POSITION:
1. NEVER unhook Land Roller if positioned between Field and Transport Position.
2. Choose a firm level surface.
3. With Land Roller in Field Position; shut off tractor, engage parking brake and relieve hydraulic
pressure by cycling remote lever.
4. Block rollers to prevent movement after hitch pin is removed.
5. Check that hitch pin is not bound with sideways or front to back pressure. If hitch pin is not free,
carefully reposition tractor.
6. Rotate jack into vertical position and extend jack until hitch piece lifts off tractor drawbar.
7. Disconnect wiring harness, hydraulic hoses and safety chain.
8. Recheck that hitch pin is free, if so, stand to the side of the hitch and remove hitch pin.
9. Carefully drive ahead.