Steffy Wood Products Multi-Section Storage - Manual (Page 2)

SHELF
TOP PANEL
SIDE PANEL
CONNECTING BOLT
SHELF
BOTTOM PANEL
SLOTS FOR BACK
2
Attach the lower dividers to the shelf and bottom panels. Insert
the plastic connectors in the dividers to the connecting screws
on the shelf. Be sure the rounded edge of the divider is facing
down and the slots for the shelves are facing up. Using an
appropriate size screwdriver, turn the screw located in the
plastic connector clockwise until tight.
Attach the bottom panel to the dividers using the connecting
bolts and hex key. Be sure the slot for the back panel is facing
up.
Attach the bumper to the bottom panel using the 1" long screw.
SLOTS FOR SHELVES
BUMPER
1" LONG SCREW
CONNECTING BOLT
3
Refer to sketch above. Attach a side panel to the bottom and
shelf using the connecting bolts and hex key. Be sure the slot
for the back panel is aligned with the slots in the shelf and
bottom panel. Attach the top panel to the side making sure the
slot for the back panel is aligned with the slot in the side panel.
Refer to sketch at left. Slide the shelves into the slots in the
dividers and side panel.
4
Refer to sketch at right. Slide the long back
panels into the slots in the shelf and top
and the short backs into the slots in the
bottom and shelf. Be sure the panel next to
the side is completely in the slot in the side
panel.
LOWER DIVIDER
ROUNDED EDGE FACING DOWN
BOTTOM PANEL
Long back panel
Short back panel