Electrix Framing System - Manual (Page 3)

3
G H
J
10. Apply Corner Bead and “J” Bead at Top and
Bottom Corners. (Figures L&M). Finish
inside wall corner with compound and tape
(not supplied).
K
L M
9. Cut and apply Front Face with the
appropriate sheetrock screws (not supplied)
(Figure K). 2-1/2” recommended face height
but may vary. Line of sight issues must be
addressed by architect. Note overhang of
front face. (Figure L). This ensures clean
corner seams. (Figure M).
7. Cut Sheetrock (by others) between
6-3/4”—6-7/8” width and apply as Bottom
Face. Use the appropriate sheetrock
screws (not provided):
• 1” Maximum for 1/2” Sheetrock
• 1-1/4” Maximum for 5/8” Sheetrock
Screw in vertically at front. (Figure G).
Screws at rear are slightly angled. (Figure H).
8. Bottom face installed. Ready for front face
installation. (Figure J). Note the 1/2”
support for the vertical face.